Equipped with STM32F722 MCU which has powerful computing ability and fast running speed, and high sensitivity ICM20602 six-axis motion sensor. It can perfectly support bidirectional DShot digital throttle communication. The integrated OSD chip can adjust and set each OSD parameters in FC parameter adjustment software and radio, which is simple and convenient. On-board large capacity Flash memory chip can record and store more flight logs, which is convenient for users to debug aircraft based on flight data.
With DJI image transmission system port, equipped with corresponding flat cable (FC has been equipped), can avoid welding, realize plug and play.
FMU integrates with 12V BEC circuit. It can supply super power output for image transmission and 12V LED devices.
FC integrated Pit Switch module can open or close VTx by radio after being adjusted on FC parameter software. Easy and convenient.
It support the firmware of BetaFlight , Cleanflight , Butterflight , inva and other mainstream FPV, and can use corresponding parameter adjustment software to adjust various parameters, making the FC more suitable for various FPV flight and race.
The double hole distance mounting hole design (30 * 30MM & 20 * 20MM) can adapt to different frames. The unique flexible flat cable connection mode (The effect is better with hobbywing tower 4in1 ESC ), and the shock absorption mechanism of installation hole, can effectively reduce the impact of external vibration on FC high-sensitivity components, and make the flight more stable and accurate.
Match with Hobbywing tower 4in1 ESC, easy to install and wire. The appearance is more beautiful.
XRotor Micro 40A 4in1 ESC features 32bit MCU and 3rd-generation BLHeli-32 firmware,
handles 6S up to 40A per channel. The built-in voltameter module which allows FC to
monitor the battery volt & amp in real time. With this 20x20 ESC makes your electronic
stack smaller and be able to shave some grams.
High performance 32bit ARM MCU can run at 48MHz. 3IN 1 IC drive. Imported mosfet and
ceramic capacitor. 3 ounces of copper, 8 layers. Greatly reduce heat. More efficient.
The ESC flashed with the 3rd-generation BLHeli-32 firmware has great
performance & rich functions and supports adjusting parameters or upgrading
firmware via different ways (i.e. via throttle signal wire with using other
development board or a FC flashed with the Cleanfight/Betaflight firmware).
The soft mounts prevent vibrations from being transferred to the FC.
Soft wiring and welder pads for the best possible connection.
Besides the regular PWM mode, Oneshot125/Oneshot42/Multishot
modes, DShot150/300/600 modes, the latest DShot1200 mode is
also supported. In DShot1200 mode, the ESC has great
anti-interference performance and rapid response.
The ESC firmware uses hardware generated motor pwm for
smooth throttle response and silent operation. Damped light
does regenerative breaking, causing very fast motor retardation,
and it inherently also does active freewheeling.
XRotor F7 Convertible Flight Controller |
|
---|---|
Basic Features |
|
Compatible with (Multirotors) | Quadcopters |
Firmware | HOBBYWING_XROTORF7CONV |
FC Programming | Supported |
Programming via | Betaflight/Cleanflight-configurator |
Compatible with (Modes) | PWM、Oneshot125、Oneshot42、Multishot、 Dshot150、Dshot300、Dshot600、PROSHOT1000 |
Compatible with (Transmitters) | PPM、Spektrum、SBUS、SUMD、SUMH、 XBUS、IBUS、JETIEXBUS、CRSF、SRXL |
OSD | Built-in |
Voltage Monitoring | Supported |
Current Monitoring | Supported |
External Buzzer | Supported |
LED Control | Supported |
BEC | 5V @ 1.5A ; 10V @ 1.5A |
USB Port | MicroUSB |
Size & Weight |
|
Size | 32x32 mm |
Weight | 3.3 g |
XRotor Micro 40A (20x20) BLHeli_32 4in1 DShot1200 |
|
---|---|
Specifications |
|
Cont./Peak Current | 40Ax4/ 60Ax4 |
Input Voltage | 3-6S Lipo |
BEC output | NO |
Wires & Connectors |
|
Input Wires | Red-14AWG-100mm/ Black-14AWG-100mm |
Output Wires | No wires but solder tabs |
Input Connectors | XT60 plug enclosed with package. |
Output Connectors | No |
(Note: All the wire length above is the original length not the length you see from the outside.) | |
Features |
|
Firmware | Hobbywing_XRotor_BLHeli-32 Version |
ESC Programming | BLHeliSuite32 |
Stick Programming | Supported |
DEO | Supported |
Throttle Range Calibration | Supported |
Oneshot125 Mode | Supported |
Oneshot42 Mode | Supported |
MultiShot Mode | Supported |
DShot150/300/600/1200 | Supported |
Timing | Supported |
Motor Rotation | Supported |
Size | 40x33x5mm |
Weight | 12g |
Applications | 100-300mm FPVs |
《HOBBYWINGならSEKIDO》
SEKIDOではHOBBYWING社の日本国内におけるパートナーとして手を組み
ユーザー様にご満足を頂けるお値段・サービスをご提供させて頂いております。
アフターサービスプログラム(製品保証)はこちらをご覧ください。